- Start the Carsoft Ultimate Pro application; by double click the Launch Carsoft.exe icon on your desktop. When you start the program for the first time you will be asked to install the Dongle drivers. Now connect the dongle to the USB port of your computer. After this, the Dongle will be recognized by the windows operating system, and the.
- For helping viewers to install Carsoft 6.5.06 on windows 7 OS with 64 bits and using the USB-Serial to convert to test BMW car. For more information about Ca.
Use a USB cable to connect the tool with PC, when the MI6 is powered up, press the shortcut key in 5 seconds, the tool screen will pop a message to tell you that the tool will proceed upgrade, press OK to start the upgrade, the light will turn to red and in quick blink till turn to yellow and enter to start display. AMD Rolls Out Its First 2021 Graphics Driver - Get Radeon 21.1.1 Intel Adds Support for Iris Xe Max Graphics (DG1) - Get Version 27.20.100.9168 The New RTX 461.09 Graphics Driver Adds Support for NVIDIA’s A40 GPU. When you plug the device into your USB, Windows will look for the associated driver, if it cannot find this driver then you will be prompted to insert the driver disc that came with your device. Common USB Device errors are ‘ usb port not working ‘, ‘device descriptor request failed error’ or ‘bugcodeusbdriver’ issues.
USB Interface Drivers: Arduino/YourDuino Nano
Most Nano boards use FTDI chips for USB interface. This uses the same FTDI drivers supplied with Arduino IDE. See it here:
Carsoft Engineering USB Devices Driver
However some use the WCH type CH340G chip and require a different driver. They are usually lower cost.
If you have this type of Nano, the USB chip on the underside of the board will be long and narrow, and marked WCH CH340G. See it HERE:
You need to install a different USB driver for these. Use the following procedure:
Download the driver software HERE:
(Your system may not allow downloading .EXE files, so click on this ZIP version):
You need Winzip or other utility to extract the EXE from the ZIP.
Before connecting the Nano to your USB port: Open “ch341ser.exe” file and run it.The software extracts about 8 files.
The software asks whether it can install the CH341SER.INF driver for the CH340 chip (Version 11/04/2011, 3.3.2011.11).
Click INSTALL
A Windows message asks whether the driver has installed correctly. Click YES.
Carsoft Engineering Usb Devices Drivers
Connect your Nano.
From Control Panel, open Device Manager and Ports. If installed correctly you should see an entry “USB-SERIAL CH340 (COMXX)
In the Arduino IDE, go to: Tools>Board (Select Nano)Tools>Port (Select the com port number found in Device Manager)<
Test by uploading File>Examples>Basics>Blink MAC Version: As always, It's Complicated. See the site HERE: